Digitrax Occupancy Detector For 16 Detection Sections $149.99 Internet Trains Price: $127.49 Item Number: DIG-BDL168 Cost effective occupancy detection for 16 detection sections Outputs for panel mounted LEDs to display local occupancy & power zone status Connect to LocoNet to transmit occupancy information to your LocoNet System Detects any powered locomotive Detects un-powered rolling stock equipped with resistor wheel sets Add one or two RX4 Transponder Receivers (sold separately) and you can have
Shimpo BI2-S12 Proximity Sensor Shimpo BI2-S12 Proximity Sensor The Shimpo BI2-S12 Proximity Sensor is a three wire DC inductive proximity sensor. Scroll down to see more details and specifications. Shimpo BI2-S12 Proximity Sensor Features Short circuit and overload protection LED output indicator NEMA 1, 3, 4, 6, 13 and IEC IP67 rated Use 4.7 kilohm pull-up resistor if an open collector input is not available Power 10-30VDC (positive) Sensing Distance 2 mm Switching Frequency 1.5kHz maximum Cable Length 2
LINROSE B4302F5-5V 3MM GREEN LED Linrose B4302F5-5V 3mm green LED Linrose B4302F5-5V 3mm 5V green LED with mounting clip and integral resistor. LED Type: THRU HOLE. Industry Size: T-1. Metric Size: 3.0 mm. Output Color: GREEN. Epoxy: GREEN DIFFUSED. Peak Wave length (mA): 565. Minimum MCD: 1.6. Typical MCD: 8.0. Forward Volt (Typical): 5. Forward Volt (Max): 7.5. Rate Current (mA): 10. Viewing Angle (°): 60. Storage Temperature: -0.55. Cont Forward Current Max: 15. RoHS Status: Yes.
YELLOW LED, BUILT-IN RESISTOR, 6?? LEADS, 12/24 VOLTS DC, PACKAGE OF 10 EACH
> PCB Mount INDICATOR, CIRCUIT BOARD, LED, 2MM, INTEGRAL RESISTOR, 5V, RED $1.10 555-2003F 511-0818 The 555 top view and right angle single series feature 2 mm standard efficiency and resistor LED with a 40 degree viewing angle. They are fully compatible with the 555 quad series. Bulb Type 2 mm Color, Emitted Color, Lens Single Finish, Lens Non-Diffused Lens Shape Luminous Intensity 1.9 mcd PCB Thru-Hole View Viewing Angle 40 ° IC Sockets, Plugs and Adapters > IC Connectors Indicators > PCB Mount
A simple red LED attached to resistor and switch. Requires 6-8V DC to light up. Pkg. of 10. Found in Components
Needed to convert the "stopper" as a second brake light.
00 HONDA MOTORCYCLE CBR 929RR interior dome light bulb LED Bulb Load Resistor 6 Ohm / 50 Watt For Signal or Brake light with Dual Filament LED bulbs upgrade USE -- LED bulbs may cause some newer vehicles to indicate a bulb is burnt out (because of their low power consumption). Some cars indicate this by increasing the flash rate of the turn signals, some turn on a bad bulb indicator. This can be remedied with our Load Resistors wired across the turn signal bulbs to simulate a filament bulb load. This 6 Ohm,
"RED FLASHING LED. BUILT-IN RESISTOR, 6\" LEADS, 12/24 VOLTS DC, PACKAGE OF 10 EACH"
> Thru-Hole Indicator, PCB, Green LED, T- 1 3/4 RA, 8 mcd, Built-In Resistor, 5V, Green Lens 5302H5-5V 679-7242 Block mounting height and spacing alignment saves assembly cost and time Full range of brightness Available with built-in resistor chip to eliminate the need for external resistor, operates off 5 V or 12 V supply TTL compatible Standoffs prevent flux entrapment Housing: black nylon For backlighting in dashboards and switches, indicator and backlighting in telephone and fax, indicator and backlight
"RED BI-COLOR LED. BUILT-IN RESISTOR, 6\" LEADS, 12/24 VOLTS DC, PACKAGE OF 10 EACH"
GREEN LED, BUILT-IN RESISTOR, 6?? LEADS, 12 /24 VOLTS DC, PACKAGE OF 10 EACH
RED LED, BUILT-IN RESISTOR, 6?? LEADS, 12/24 VOLTS DC, PACKAGE OF 10 EACH
LARGE ???? GREEN LED, BUILT-IN RESISTOR, 6?? LEADS, 12/24 VOLTS DC, PACKAGE OF 10 EACH
"LARGE ???? YELLOW LED, BUILT-IN RESISTOR, 6\" LEADS, 12/24 VOLTS DC, PACKAGE OF 10 EACH"
LARGE ???? RED LED, BUILT-IN RESISTOR, 6?? LEADS, 12/24 VOLTS DC, PACKAGE OF 10 EACH
Mini Termination Resistor W/ Led (Female) - 10% Off Red Tag Sale! Price shown reflects 10% discount. MARETRON MINI TERMINATION RESISTOR W/ LED (FEMALE)
Super Bright Flashing Giant 10mm Green LED Item Number : G16426 Detailed Description G16426 Crystal clear lens giant 10mm LED flashes brightly from a built in IC. Operate from 3VDC or can be used with a 9V battery if you connect an 82 ohm resistor in series with one of the leads. At 3VDC the flash rate is about 2X per second.
8mm LED Accent Lights BEST DEAL ON THE BEST LEDS! 8mm ALL 20 LEDs Each come with wire & resistor attached for 12V use. You need not do any work assembling! Will work for 6V-14V DC applications. 8mm is the lense diameter (same brightness) 8mm 25 degs Assembled in the USA! Best Quality! Water Proof (not recommended for long term use in water) You do not need anything else! Plug Play with any 6-14V Battery Instructions click here! 20 - 8mm or 5mm LED Accent Lights You do not need anything else buy powering