Specifications: Replaces GM part number: 15112380 Direct bolt on replacement Fits LH & RH sides Includes ABS sensor, wire, and correct connector Includes 6 wheel studs Fits 2 wheel drive, 1500 series trucks only Built to strict quality control standards Comes completely <em>preassembled</em>, ready to install Note: If your vehicle requires a match to an RPO code, you can usually find it on your original window sticker and sometimes either on the inside of your glove box door or the front, driver's side door shell
Proper selection of master cylinder bore sizes is the most important factor in achieving correct <em>brake</em> bias. A balance bar is for fine-tuning the bias in the pits or, with the addition of the adjusting cable, by the driver during competition. This high
<em>BRAKE</em> MASTER CYLINDER -- PG Plus Master Cylinder, Matched To The Design Of Your Vehicles Original Equipment, Technically Advanced Components Ensure Safe And Reliable <em>Braking</em>, Stock Replacement Series: Pg Plus
Extended Forward Control <em>Brake</em> Line <em>Assembly</em> for Harley-Davidson Softail 87-05
Lokar EC8004U Lokar Rear <em>Brake</em> Cable <em>Assemblies</em> Parking <em>Brake</em> Cables Part Number: LOK-EC8004U Parking <em>Brake</em> Mounting: Dash mount Parking <em>Brake</em> Style: Internal drum Parking <em>Brake</em> Type: Hand <em>brake</em> Cable Length (in): 48 in. Cable Brackets Included: No Cable Jacket Material: Plastic Cable Jacket Finish: Black Quantity: Sold as a kit. Parking <em>Brake</em> Cable, Under Dash, Chevy Trucks 1942-52, Kit Rear <em>brake</em> cables from Lokar. Lokar makes these rear <em>brake</em> cable <em>assemblies</em> for a variety of applications. They're
Complete Fork <em>Assemblies</em> - main 1949-67 Big Twin FL Drum <em>Brake</em> Front End <em>Assembly</em> <em>Assembly</em> replaces the stock length FL 1949-67 front end with left side drum <em>brake</em>. Available with chrome lower legs. Each front end comes complete with chrome upper and lower triple trees, hard chrome fork tubes, springs, and all internal components. Both the upper and lower triple trees have the tabs necessary for mounting headlight housing and slider covers. Headlight mounting bracket holes are 2-1/2" center-to-center.